|
Chlorodibromomethane in Methanol, AS-E0200 |
Hazard Statements
H225 - Highly Flammable (Flammable liquids, category 2). H301 - Toxic if swallowed. (Acute toxicity, oral, category 3). H311 - Toxic if absorbed through skin. (Acute toxicity, dermal, category 3) H315 - Irritating to skin. (Skin corrosion/irritation, category 2). H320 - Irritating to eyes. (Eye damage/irritation, category 2B). H332 - Harmful if inhaled. (Acute toxicity, inhalation, category 4). H336 - Overexposure may cause dizziness, nausea, muscle weakness, narcosis and respiratory failure. H351 - This product is or contains a component that is classified (ACGIH, IARC, NTP, OSHA) as a suspect cancer hazard. (Carcinogenicity, category 2). H370 - Causes damage to organs. (Specific target organ toxicity, single exposure, category 1).
Precautionary Statements
P202 - This product should only by used by persons trained in the safe handling of hazardous chemicals. P233 - Store in a tightly closed container. (P404) P262 - Do not get in eyes, on skin or clothing. P264 - Wash thoroughly after handling. Do not take internally. Eye wash and safety equipment should be readily available. P280 - Protective gloves must be worn to prevent skin contact. P284 - Respiratory Protection: If workplace exposure limit(s) of product or any component is exceeded (see TLV/PEL), or a risk assessment shows air-purifying respirators are appropriate, use of a NIOSH/MSHA approved air supplied respirator is advised. Use a full-face respirator with multi-purpose combination (US) or type ABEK (EN14387) respirator cartridges in absence of proper environmental control. Always use respirators and components tested and approved under appropriate government standards such as NIOSH (US) or CEN (EU). Engineering and/or administrative controls should be implemented to reduce exposure. P331 - Ingestion: Do NOT induce vomiting. Call a physician or poison control center immediately. Never give anything by mouth to an unconscious person. P338 - Eye contact: Immediately flush with plenty of water. After initial flushing, remove any contact lenses and continue flushing for at least 15 minutes. Assure adequate flushing by separating the eyelids with fingers. P360 - Skin contact: Immediately wash skin with soap and plenty of water. Remove contaminated clothing. Get medical attention if symptoms occur. Wash clothing before reuse.
Manufacturer information
Name
Accustandard Inc
Phone
203-786-5290
Address
125 Market St.
New Haven, CT 06513
PICTOGRAMS
HMIS
| HEALTH |
2 |
| FLAMMABILITY |
3 |
| PHYSICAL HAZARD |
0 |
| PERSONAL PROTECTION |
|
NFPA
2
3
0
University of North Dakota
Local data
SKU #